Silhouet-Tone Steamer Vapo XV Stream

Description

Silhouet-Tone Steamer Vapo XV Stream cerrtified device is equipped with a 360° double
rotating arm and nozzle, as well as a stable and ergonomic pneumatic base* for precise
height adjustments. The steel-built Vapo XV Stream is ready to go in 7 minutes.
It generates a very thick plume of steam, making it easier to perform extractions.

Features
Ready to use in 7 minutes
60-minute timer with audible signal
Versatile positioning thanks to three rotational axes (360°column, 360°arm and 360° nozzle)
Fixed arm angle to facilitate the constant diffusion of steam
Generates a significant amount of steam and a steady and highly visible plume of steam
Constant temperature monitoring and control
Clear water jar to visually monitor the water level
Ability to activate or deactivate the emission of ozone (ON/OFF switch)
Sturdy design
Electrostatic paint
Components made from high quality raw materials (non-toxic)
Safety systems (automatic shut-off feature when water level is too
low and in the event of overheating or overloading)
Casing made mostly of 18 Ga (0.0478’’)
700 W heating element
CSA-US certified
Base not included
How To Use
It is essential to allow the steamer to cool down completely before draining
and returning it to the rental facility. If there are any concerns about the operation
or safety of the equipment, do not use it! Instead, contact customer service for assistance.
Failure to follow these instructions may lead to potential injury.
Check the steamer to ensure it is empty of water. If not, empty all water.
Add one gallon of water, preferably distilled water. Securely replace the fill cap,
but do not over-tighten. (The steamer will produce steam for approximately one hour with one gallon of water.)
Plug the steamer into a 120-volt, 15-amp grounded outlet. Do not use an extension cord.
Place the steam pan into a clean bucket or paint pan until the steamer reaches the desired
temperature and starts producing steam (approximately 15 to 20 minutes).
After approximately one hour of steaming, check the water level gauge. Unplug the steamer
and remove the fill cap. Replenish the water to the proper level. Exercise caution when
removing the cap from a steamer that has been in use, as hot steam may escape from the fill pipe.
Use warm water and never pour cold water into a hot steamer.
Do not let the steamer run out of water. If it does, unplug it and allow approximately 15 minutes
for it to cool down. After the steamer has cooled down, refill it with water and press the
reset button located inside the finger hole on the service door. Never pour cold water into a hot steamer.
For this 120-volt equipment, make sure to use a grounded outlet and do not modify the plug.
Always wear appropriate safety attire, including eye protection and rubber insulated gloves.
It is important to operate any equipment safely to avoid potential dangers. As the operator,
it is your responsibility to ensure the safe operation of this equipment. Please carefully
read and follow all warnings, safety signs, and instructions provided with or attached to the equipment.
It is crucial not to remove, disable, deface, or render any of the safety devices or warnings
on this equipment inoperable. If any safety devices or warnings have been tampered with,
do not use this equipment!